Operating instructions

This cleaning program takes about 15 minutes. Please use one
white cleaning tablet (enclosed). The machine comes with a
pack of 2 tablets. To re-order cleaning tablets see chapter 22.
Important: Once the cleaning program has started do not
interrupt the procedure.
• Make sure the machine is on and the water tank is full.
• Push and hold the Rinse button until the display shows
EMPTY TRAY.
• Remove and empty the drawer and replace complete
assembly (Fig. 23).
Important: Even if the drawer is empty, you still need to remove
it for approx. 20 seconds and then replace it.
The display shows PRESS MAINT.
• Push the Rinse Button (Fig. 3b). The display shows MACHINE
CLEANING. After a moment the machine beeps and the
display shows TABLET PRESS MAINT..
• Open the ground coffee lid and drop in one white cleaning
tablet (Fig. 24).
• Push the Rinse button. The display shows MACHINE
CLEANING. The cleaning program will dispense hot water in
intervals through the coffee spout into the drawer.
• When finished, the display shows EMPTY TRAY and the
machine "beeps".
• Lift and remove the drawer. Empty the used coffee container
and drawer and replace. The display shows SELECT
PRODUCT indicating the machine is now ready to brew
coffee again.
20b. DECALCIFYING PROCEDURE
The machine has an integrated decalcifying program. When the
display shows MACHINE SCALED SELECT PRODUCT it is
time to decalcify the machine. You can still make coffee
however, it is highly recommended that you decalcify the
machine within the next 3 to 4 days.
Please note: If you use the Claris water car
tridge and the
display shows MACHINE SCALED SELECT PRODUCT, then
your cartridge function is not activated. Follow the instructions in
chapter 16a to program the Claris Cartridge function.
Important: The decalcifying program must not be interrupted.
DECALCIFYING AGENT: Only use our special decalcifying
tablets. For supplies see chapter 22.
CAUTION: Never use vinegar or any other decalcifying agent.
This might damage internal parts of the machine.
1. Turn off machine and let cool down for at least one hour.
2. With the machine off, push and hold the Rinse Button (Fig. 3b)
until the display shows EMPTY TRAY.
3. Remove and empty the drawer and replace complete
assembly (Fig. 23).
Important: Even if the drawer is empty, you still need to remove
it for approx. 20 seconds and then replace it. The display shows
AGENT IN TANK PRESS MAINT..
4. Dissolve two of the large, white square tablets in 16 oz. of
water and pour this mixture into the water tank.
Please note: Do not use more than 16 oz. of water.
5. Replace water tank.
6. Place a container (at least 16 oz.) underneath the frother.
The displays still shows AGENT IN TANK PRESS MAINT.
23.