Operating instructions

• Touch the arrow until the display shows STEAM 60 SEC.
• Touch ST@RT. The number 60 starts blinking.
• Touch either arrow repeatedly until the desired duration is
shown.
• Touch ST@RT to confirm.
• Press P button to return to SELECT PRODUCT.
Please note: During steaming you can always stop the flow of
steam by simply pushing the Steam Button. This will not change
the setting. When the steam output stops you can immediately
resume steaming by pressing the steam button again.
18f. PROGRAMMING WATER PORTION
The Hot Water Button can be programmed to dispense any
amount up to approx. 16 oz. (480 ML). The factory setting is
5 oz. (150 ML).
• Press the P-Button.
• Touch the right arrow until the display shows WATER PORTION.
• Place a cup or container underneath the frother (Fig. 15 ).
• Touch ST@RT. The display shows PRESS KEY and the red
light in the Hot Water Button illuminates.
• Push the Hot Water Button. Hot water will be pumped through
the frother into the cup. The display reads ENOUGH WATER?
PRESS KEY.
• When the desired amount of hot water is dispensed, push the
Hot Water Button to stop the flow. The amount of hot water in
your cup is now programmed. The display shows WATER
PORTION.
• Press the P button to return to SELECT PRODUCT.
Please note: When pumping hot water through the steam
nozzle you can always stop the flow of hot water by simply
pushing the Hot Water Button. This will not change the
programmed setting. When the hot water output stops, you can
dispense more by pressing the Hot Water button again.
18g. SETTING THE TIME
You can enter the actual time into the machine. Once the time is
set you can then program the machine to turn on at a specific
time (next chapter).
Please note: The time is displayed in the 24 hr mode (not AM/PM).
If the actual time is 3:45 pm you must set the time to 15:45.
• Press the P-Button.
• Touch the right arrow until the display shows TIME --:-- .
• Touch ST@RT. The hour segment starts blinking.
• Touch either arrow repeatedly to set the hours.
• Touch ST@RT to confirm. The minute segment starts blinking.
• Touch either arrow repeatedly to set the minutes.
• Touch ST@RT to confirm. Now the actual time is set.
• Press the P button to return to SELECT PRODUCT.
Please note: The Impressa F9 will keep the time as long as the
machine is plugged in. If you unplug the machine or if you have
power interruption, the time will be lost.
18h. SETTING THE AUTO-ON TIME
You must first set the time (chapter above).
You can set the machine to turn on at a specific time. It will turn
on at that time, warm up and the display shows PRESS MAINT.
Press the Rinse Button and you are ready to brew coffee.
• Press the P-Button.
• Touch the right arrow until the display shows UNIT ON --:--.
20.