Impressa E Series Fully Automatic Coffee & Espresso Center with Clearyl Water Care System Operating Instructions and Warranty 64701R Customer Service 1-800-220-5701
IMPORTANT SAFEGUARDS wall outlet. To disconnect, turn any control to “off” then remove plug from wall outlet. 12. Do not use appliance for other than intended use. 13. Use extreme caution when disposing hot steam. 14. For household use only. When using electrical appliances, basic safety precautions should always be followed, including the following: 1. Read all instructions. 2. Do not touch hot surfaces. Use handles or knobs. 3.
D. This appliance has a polarized plug (one blade is wider than the other). As a safety feature, this plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. Do not attempt to defeat this safety feature. JURA-CAPRESSO Jura was founded in 1931 in Switzerland. Capresso was founded in 1994 in the USA.
a. On/Off b. 1-Cup mild normal strong d. 2-Cup e. Dial f. Rinse Fig. 6 g. Steam h. Pre-Ground Coffee e. Programming Fig.
Fig. 13 Fig.
Frothing: down Steaming: up Fig. 15 Fig. 19 Fig. 16 Fig. 20 Fig. 17 Fig. 21 Fig.
Table of Contents Page Page Important Safeguards / Jura-Capresso...............................2 Illustrations.......................................................................4–7 1. Product Registration......................................................9 2. Operating Instructions / Customer Service...................9 3. WELCOME TO THE IMPRESSA E SERIES ...............9 a. "Crema Coffee" and Pressure Brewing ...................9 b. Different Coffee Drinks..........................................
1. PRODUCT REGISTRATION Please read the enclosed product registration form now. Fill it out and mail or fax it to us within two weeks after purchasing your machine or register online through our website: www.capresso.com. Important: This registration is part of your warranty (chapter 24). sure brewed coffee. Just press one of the two cup buttons and your Impressa E will grind, tamp and brew your personal cup of coffee. The integrated solid steel conical burr grinder grinds beans to the preferred fineness.
extraction of bitter oils and release less caffeine than any other brewing method. You will always make the absolute freshest and most aromatic cup of coffee. This is the reason why many European restaurants and hotels serve fresh pressured brewed coffee only. Experiment with your new machine and prepare yourself the best and most enjoyable cup of coffee! prepared. Typical US espresso roasts result in darker beans with an oily outside.
All Display Messages Are Shown in RED 5. FACTORY SETTINGS Each machine leaves the factory with the following settings: Filter ..................... NO Hardness Level .... 2 Aroma ................... ROBUST Auto Off ................ 2 hours after last use Language ............. English Cup Size ………….. OZ. Rinse ……………… ✔ The Dial is set to 4 OZ. for coffee and for hot water and for 60 SEC for steam. 6.
Sugar Coated Beans: DO NOT fill sugar coated beans into the bean container. The sugars will stick to the burrs and clog the flow of ground coffee. Have your local coffee store grind the sugar coated beans and use as described in chapter 11. Using Oily Beans: Beans with an oily surface tend to stick together. This may prevent a continuous flow of beans from the bean container into the burrs. As a result the grinder does not grind enough coffee and you might get weak or no coffee at all.
Grinding times (approx.) MILD .......... 6 to 7 seconds. NORMAL ... 7.5 to 8.5 seconds. STRONG..... 9 to 10 seconds. • Open the lid for the ground coffee funnel (Fig. 1.8) and fill the funnel with one or two scoops of ground coffee. Important: Do NOT fill this funnel with instant coffee and do not use more than two level scoops of coffee. • Push the 1-Cup or 2-Cup button. The machine will tamp and brew coffee. Please note: If you push the scoop button accidentally push the 1-Cup button.
13. FROTHING and STEAMING The steam function can be used to heat up any liquid and to steam and froth milk. Steaming Position: The Frother's metal cylinder is in the UP position (Fig. 16). In the steaming position hot steam is injected into the milk (or any other liquid) without creating a frothy layer on top. Typically a Latte has steamed milk with no froth. Frothing Position: The Frother's metal cylinder is in the DOWN position (Fig. 16).
• Assemble the Dual Frother and make sure that the tip is screwed onto the Connector finger tight (Fig 14a, c). • Push the black Clip-on Connector (Fig.14c) firmly into the steam nozzle (the connector should sit flush with the chrome sleeve (Fig. 15b) so that the steam nozzle is no longer visible). Please note: If the parts are not put together tightly it will not be possible to create the frothy foam on top of the milk. 15.
• Insert the cartridge with its tapered end down. Make sure it fits snugly over the white mesh piece inside the water container. Push down gently (Fig.10). • Close the holder for the cartridge so that it engages in the water tank (Fig.11). • Fill the water tank with fresh cold water and replace. You must activate the cartridge as follows: 1. Push and hold the P button (Fig. 3e). FILTER – 2. Push the Dial and the display shows NO – 3. Turn the Dial until the display shows YES ✔ 4. Push Dial confirm.
. ADJUSTING THE WATER HARDNESS Water is heated inside the machine. With use, this leads to calcium deposits forming inside the machine. The display will remind you when it is time to perform a decalcifying cycle. The machine is set to level 2 (medium hard water). If you have harder water you need to set it to a higher level. If you have softer water you can set it to level 1. If you are not sure about the hardness of your water, ask your local water company for the "Water Hardness in Grains.
a. AROMA 1. Push and hold P button until display shows FILTER. 2. Turn Dial to AROMA 3. Push Dial: ROBUST 4. Turn Dial to select from STANDARD or ROBUST 5. Push Dial to confirm selection. 6. Push the P button to get back to READY. In ROBUST the grinder will always grind approx. 1 second longer to increase the strength of your coffee. works more effectively after the brewing chamber has cooled down. 18c. STATS (usage) 1. Push and hold P button until display shows FILTER. 2. Turn Dial to STATS 3.
18f. RINSE You can turn off the automatic rinsing mode for when the machine shuts down. 1. Push and hold P button until display shows FILTER. 2. Turn Dial to RINSE 3. Push Dial: RINSE ✔ 4. Turn Dial to select RINSE – 5. Push Dial to confirm selection. 6. Push the P button to get back to READY. • Place the used coffee container on the tray and insert back into the machine (Fig. 21). The display shows READY and you may now continue brewing coffee. 19c.
19e. GENERAL CLEANING INSTRUCTIONS Never use abrasive materials or chemicals to clean the machine. • Clean the housing with a soft, damp cloth. • Rinse water tank daily and fill with fresh, cold water. • Push the Dial. Hot water is dispersed through the coffee spouts and will stop automatically. READY. 20b. CLEANING WITH SPECIAL TABLET The machine monitors how many coffees are brewed and how often the rinsing program is activated. After approx.
7.Push the Rinse button. The display shows CLEANING. The cleaning program will dispense hot foamy water in intervals through the coffee spout into the drawer. 8.When finished, the display shows EMPTY DRAWER. 9.Lift and remove the drawer. Empty the used coffee container and drawer and replace. The display shows READY indicating the machine is now ready to brew coffee again. Attention: You can run a tablet cleaning cycle at anytime even if the machine does not prompt you, • READY.
9. Place a large container (at least 20 oz.) underneath the frother. The display shows OPEN TAP. 10. Turn the Steam/Water Selector to the water symbol. The machine will pump hot water through the frother in intervals. During this procedure the display shows DECAL ON. When this cycle is finished the display shows SHUT TAP. 11. Turn the Steam/Water Selector back to the cup symbol. The display shows DECAL ON. Now the machine pumps hot water through the coffee spout into the drawer. 12.
24. TROUBLESHOOTING A. NO COFFEE COMES OUT OF THE COFFEE SPOUT Reason: Beans in bean container are not feeding properly into the grinder because they are stuck together. Solution: Stir beans before grinding and while grinding turn the grinding selector to the coarsest setting. See chapter 7. Reason : You used ground coffee in the ground coffee funnel. The ground coffee was too fine. Solution: Use ground coffee which is ground somewhat coarser. Reason : No water is transported through the system.
25. WARRANTY For Home Use: Limited One Year Warranty For Non-Home Use: Limited Six Month Warranty This warranty covers your new IMPRESSA E Series. This warranty is in effect for the period described above from the date of the first consumer purchase and is limited to the United States of America. This warranty covers all defects in materials or workmanship (parts and labor) including UPS ground transportation for both ways, if necessary.
