User Guide

13
Cleaning the Brew Head and Portalter
a) Both the brew head and portalter should be cleaned frequently.
b) Wipe the brew head (Fig. 7) with a clean, damp cloth.
Caution: HOT! Danger of burning or scalding! Ensure the machine has completely
cooled down prior to cleaning.
c) If the inner screen inside the brew head, accumulates coee oils, it can be removed
for a thorough cleaning using a screwdriver. Ensure it is attached back onto the
machine the same way after cleaning.
d) After removing used coee from the portalter, unlock the sieve from the portalter
by aligning the bump on the sieve with the notch on the portalter and lift up (Fig. 2).
Wash the portalter and sieves with warm water. Do not use harsh or abrasive
cleaners, or alcohol/solvent-based cleaners to clean the brew head or portalter.
When cleaning the portalter and sieves, hold under running water. Rinse well and
dry carefully.
e) When the espresso machine is not in use, do not store the portalter in the locked
position. This will avoid unnecessary wear to the seal.
Important: Never wash the loose parts or accessories in the dishwasher. Hand
wash only!
15. Descaling the Machine
When making espresso always use cold, clean water. Using spring water or ltered water
will slow down calcium build up. We recommend descaling the machine after 100-200
uses or at least every 2-3 months. Empty the water tank and ll the tank with a mixture
composed of 30 oz. of water and one packet of Capresso Cleaning Solution or similar
descaling agent.
NOTE: Do not use vinegar as this will considerably shorten the life of the seal inside the
brew head.
Descaling the Brew Head
a) Remove the portalter.
b) For best results unscrew the screen inside the brew head. Wipe any coee residue
with a damp cloth.
c) Fill the water tank with the descaling solution and water.
d) Place a large container beneath the brew head.
e) Press the 2-Cup indicator and allow water to ow into the container. Repeat this
process again then allow machine to sit for 15 minutes. Press the 2-Cup indicator
again to run more Cleaning Solution through the machine. Empty the container of
used Cleaning Solution.
Descaling the Steam Wand
f) Place the empty container under the steam wand.
g) Press the Hot Water indicator and turn the steam control knob to the open position.
Let the remainder of the Cleaning Solution ow through the steam wand into the
container and then turn the steam control knob to the closed position.
Rinsing the System
h) Remove the water tank and rinse thoroughly, then ll with fresh, cold water and
place back onto the machine.
i) Repeat above steps (d through g) with fresh, cold water.
j) Replace screen in the brew head and tighten the screw securely.