CoffeeTEAM Glass 12-Cup Digital Coffee Maker / Conical Burr Grinder Combination • Operating Instructions • Warranty Model #477 1000W/120V~/60Hz Read this manual thoroughly before using and save it for future reference
IMPORTANT SAFEGUARDS When using electrical appliances, basic safety precautions should always be followed, including the following: 1. Read all instructions. 2. Do not touch hot surfaces. Use handles or knobs. 3. To protect against fire, electric shock and injury to persons, do not immerse cord, plugs, or body of machine in water or other liquid. 4. Close supervision is necessary when any appliance is used by or near children. 5. Unplug from outlet when not in use and before cleaning.
SPECIAL CORD SET INSTRUCTIONS This appliance has a polarized plug (one blade is wider than the other). To reduce the risk of electric shock, this plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. Do not modify the plug in any way. A. A short power supply cord is provided to reduce the risk resulting from becoming entangled in or tripping over a long cord. B.
8 Fig. 1 5 6 7 9 1 11 2 12 10 3 13 14 15 4 16 1. GoldTone filter 9. Removable upper burr 2. Filter insert with drip stop 10. Fixed lower burr (not removable) 3. Filter holder 11. Water container lid 4. Carafe 12. Removable water container 5. Digital display (Fig. 2) 13. Steam vent 6. Fineness knob / Upper burr release (Fig. 4) 14. Charcoal filter holder (Fig. 11) 7. Removable bean container 16. Brush 15. Scoop 8.
Fig. 2 Fig. 3 Fig. 4 Fig. 5 Fig. 6 Fig. 7 Fig. 8 Fig. 9 Fig. 10 Fig.
3. COFFEE BEANS AND THE BUILT-IN BURR GRINDER Grinding the beans just before brewing will maximize the flavor and aroma of your coffee. Conical burr grinders are considered the best way of grinding beans. The slower grinding speed of the conical burrs creates less heat thus preserving more aroma of the ground coffee. Following the recommendations below will make your coffee taste better and your machine last longer. a.
How to avoid stones entering the bean container: • Shake coffee bag thoroughly, so any stones will fall to the bottom of the bag. • Before emptying the bottom half of the bag of beans into the bean container, check to see whether there are any particles that look like stones, and remove them.
• Rinse out the water tank for first time use and fill the water tank to the 12 cups marking. Place back onto the machine and press down to fully engage the base valve. • Remove the charcoal cartridge and measuring scoop from the carafe and wash the carafe as described in chapter 10.1. NOTE: The filter insert, GoldTone filter, the glass carafe and carafe lid are dishwasher safe (upper rack, away from any heating element). CAUTION: Do not immerse the machine in water or any other liquid.
c) To change the Auto-On Time • Push and hold the AUTO button for 2-3 seconds until the display illuminates with the clock icon and the clock icon starts blinking. • Push and hold the HOUR and then the MINUTES button to set a new Auto-On time. • Select the number of cups you would like to brew automatically by pressing the CUPS button or choose GROUND COFFEE. See b) Setting the Auto-On Time above. • Once desired Auto-On time is programmed, press the AUTO button again.
7.4 REMOVING / ATTACHING THE BEAN CONTAINER • Grasp the bean container with two hands and turn the bean container clockwise. • The machine will beep, indicating that the bean container is no longer locked. • Once the bean container is unlocked, lift straight up off of the machine. The door on the bottom of the bean container will keep any beans from falling out of the bottom of the bean container. • To remove and replace the upper burr see chapter 7.5 below.
NOTE: If the bean container lid is not in place when the BREW button is pressed, the machine will beep indicating there is an error. Push down on the lid to fully engage the lid. 7.7 FILLING THE WATER CONTAINER • Grasp the back section of the water tank and pull the water tank straight up. • Open the water container lid (Fig. 1.11) and fill the water container with the desired amount of fresh, cold water.
CAUTION/ DANGER! • Never use the coffee maker without the filter insert and GoldTone filter. Extremely hot water can overflow onto the warming plate and counter. If this occurs, turn the machine off, unplug and wait until the brewing stops. • Then push the filter holder button, add the filter insert and the GoldTone filter and close the filter holder. Place the carafe underneath and continue brewing until the water tank is empty. 7.
8.1 DRIP STOP / STOP AND SERVE • While the coffee is brewing you can remove the carafe to pour a cup or two. The drip stop will close automatically. • To avoid any overflow, replace the carafe within 20 seconds. CAUTION: The drip stop might not close completely allowing coffee to drip onto the platform. In this case immediately place carafe back into the machine and let all the coffee flow into the carafe.
To turn off the Auto-On feature press the AUTO button again until the clock icon disappears. • At the preprogrammed time, the clock icon will turn off, the cup icon and ground coffee icon will illuminate and the brewing will start. 10. CLEANING CAUTION: Make sure machine is turned off, unplugged and cooled down prior to cleaning. Never use scouring agents. Never immerse the machine in any liquid. Never clean machine under running water. Never submerge the conical burrs or allow them to get wet.
10.6 Conical Burrs: Once a week, remove the bean container and upper burr as described in chapters 7.4 & 7.5 to remove coffee buildup from the upper and lower burrs. • Once upper burr is removed, use included brush to remove any left over ground coffee from the upper burr then use the brush to remove any coffee build up in the lower burr chamber. IMPORTANT: Never try to remove the lower burr! 11.
- Please follow the steps outlined in chapter 10.5 & 10.6 to clean the grinder and grinder chute. - Double check that the upper burr is locked into place before grinding. - Call Customer Service for additional guidance to remove tough clogs. Upper burr does not fit back into the machine. - Double check that the fineness knob is in the RELEASE position before placing the upper burr back into the machine, as described in chapter 9. - Follow location of upper burr handle as shown in Fig. 8 & Fig. 9.
LIMITED ONE YEAR WARRANTY This warranty covers your CAPRESSO machine, model #477 CoffeeTEAM PRO Glass. The model # can be found on the bottom of the machine. This warranty is in effect for one year from the date of the first consumer purchase. This warranty covers all defects in materials or workmanship (parts and labor). This warranty does not cover: • Any machine not purchased from an Authorized Capresso Dealer. • Commercial use of the machine.
