Technical data

46
6 Maintenance
M l Press the Rotary Switch to enter the programme item.
RINSE
Ä l Turn the Rotary Switch until CLEAN appears.
M l Press the Rotary Switch.
EMPTY TRAY
l Continue with the second prompt to take action (indicated
by
l), as is described under ‘Cleaning following a prompt’.
The IMPRESSA builds up deposits of limescale over time and auto-
matically prompts you to descale it. The degree of calcification
depends on the degree of hardness of your water.
If the descaling agent comes into contact with the skin or eyes, this
can cause irritation.
l Avoid contact with the skin or eyes.
l Rinse the descaling agent off with clean water. Should you get
any descaling agent in your eye, see a doctor.
If the wrong descaling agent is used, the machine could be dam-
aged and/or traces of detergent could be left behind in the water.
l Use only original JURA care products.
If the descaling operation is interrupted, there may be damage to
the machine.
l Allow the descaling program to run to the end.
If the descaling agent comes into contact with sensitive surfaces,
damage cannot be ruled out.
l Clean up any splashes immediately.
o The descaling programme lasts approx. 40 minutes.
o JURA descaling tablets are available from your stockist.
o If you use a CLARIS filter cartridge and this is activated, you
will not be prompted to change the filter.
@ You can also try out the ‘Descale machine’ operation online.
Visit the Knowledge Builder at www.jura.com.
Descale machine
CAUTION
CAUTION
CAUTION
CAUTION