Use and Care Manual

16.
Uneven cup filling.
Loud pump noise/no water
from brew head.
Water tank drips/leaks
when removed.
The appliance does not
operate
(no power).
Outlet in sieve or portafilter
blocked.
Uneven dosing or tamping
of ground coffee into sieve.
No water in water tank.
Air blockage in pump.
Water tank is not in the
correct position.
The base valve on the bottom
of the water tank may be
stuck.
Not plugged in/power outlet
damaged.
Mechanical or electronic
defect.
Remove sieve from portafilter.
Clean with stiff brush. Clean
portafilter.
Evenly distribute the finely
ground coffee into the sieve
and tamp firmly and evenly.
Fill water tank with fresh,
cold water.
Coffee/Steam switch should
be in the steam position.
Place small frothing pitcher
under frothing wand and turn
Selector Dial to steam. After
a few seconds a steady
stream of water should
emerge from the frothing
wand. Allow a few ounces
of water to flow out of the
frothing wand then turn the
Selector Dial back to the
center position "•".
Adjust the water tank so it is
in the right position. See
chapter 3, a.
Use finger to push valve
back into place while holding
the water tank over a sink.
Plug the power cord into
a functioning wall outlet
correctly, if the appliance
still does not work, please
contact Jura Capresso
Customer Service.
Contact Jura Capresso
Customer Service.
Symptom Cause Corrections