Instruction manual for in-column wine cabinet Model code: WC6215 Contact Caple on 0844 800 3830 or for spare parts www.4caple.co.
WARNING z z z To prevent damaging the door gasket, make sure to have the door all the way opened when pulling shelves out of the rail compartment. The appliance must be positioned so that the plug is accessible. Release the electric cord. Move your cabinet to its final location. Do not move your Cabinet while loaded with wine. You might distort the body. The wine cellar should be installed in a suitable place in order to avoid Touching the compressor with the hand.
INSTALLATION INSTRUCTIONS ¾ Before Using Your Wine cabinet • Remove the exterior and interior packing. • Before connecting the Wine cabinet to the power source, let it stand upright for approximately 12 hours. This will reduce the possibility of a malfunction in the cooling system from handling during transportation. • Clean the interior surface with lukewarm water using a soft cloth. • When disposing your appliance, please choose an authorised disposal site.
OPERATING YOUR WINE CABINET AND SETTING THE TEMPERATURE CONTROL Please use the cabinet within a ambient temperature of 5-32 ºC. If the ambient temperature is higher or lower than this, it will cause a temperature fluctuation in the cabinet, impairing its performance. ¾ Controls LCD touch panel. • “POWER” When the indicator light is on, the power for the machine is on. • “ ” This shows the temperature of the internal cabinet.
¾ Setting The Temperature Controls • The temperature setting range as below: Upper compartment: 5～10ºC Lower compartment: 10～18ºC • The factory set temperature is as below: Upper compartment: 6 ºC Lower compartment: 12ºC • When the system enters the temperature set up. With each press on the button, the temperature setting of the upper zone will increase by 1 ℃ , When the temperature setting reaches the upper limit of 10ºC, the temperature will return to 5ºC.
¾ Storage diagram Total: 42 bottles (Max) (for 750 ml Bordeaux bottles) Fc O O ¾ Shelves • • • To prevent damaging the door gasket, make sure to have the door fully opened when pulling shelves out of the rail compartment. For easy access to the storage content, you must pull the shelves approximately 1/3 out of the rail compartment, however this unit was designed with a notch on each sides of the shelf tracks to prevent bottles from falling.
¾ How to change the door opening This appliance has reversible doors but is delivered with a right hinged door. The left hand hinge kit comes with the unit (in the box), should you wish to reverse the hinge on your unit.
1. Incline the wine cabinet 45 degrees, take out right lower hinge’s screws with screwdriver (Fig.1) 2. Level the wine cabinet, hold the door and take out right upper hinge’s screws with screwdriver. Then take out the door and rotate 180 degree (Fig.2 & Fig.3 & Fig.4) 3. Take off the decorated nail from left upper side and fit the door with screws .Then fit the decorated nail to right side of A location. (see Fig.5& Fig.
1. After installing wine cellar into cabinet, please adjust limited block (a) close to cabinet (b) 2. Please fix the 3 screws through the limited block (a) into the cabinet (b) to fix into place. Please find below picture for reference a、Limited block b、Cabinet c、Screw d、Screwdriver CARE AND MAINTENANCE ¾ Cleaning Your Wine cabinet • Turn off the power, unplug the appliance, and remove all items including shelves and rack. • Wash the inside surfaces with a warm water and baking soda solution.
¾ Moving Your Wine cabinet • Remove all items. • Securely tape down all loose items (shelves) inside your appliance. • Wind the adjustable leg up into the base to avoid damage. • Tape the door shut. • Be sure the appliance stays secure in the upright position during transportation. protect outside of appliance with a blanket, or similar item. Also ¾ Energy Saving Tips • The Wine cabinet should be located in the coolest area of the room, away from heat producing appliances, and out of the direct sunlight.
PROBLEMS WITH YOUR WINE CABINET? You can solve many common Wine cabinet problems easily, saving you the cost of a possible service call. Try the suggestions below to see if you can solve the problem before calling the service centre. TROUBLESHOOTING GUIDE PROBLEM Wine cabinet does not operate. Wine cabinet is not cold enough. Turns on and off frequently. The light does not work. Vibrations. The Wine cabinet seems to make too much noise. The door will not close properly. POSSIBLE CAUSE Not plugged in.
DEFROSTING/CONDENSATION Your wine cellar is designed with an “Auto-cycle” defrost system. When the RUN cycle is OFF, the refrigerated surface of the wine cellar (interior rear wall) defrosts automatically. The defrost water is channelled into a drain pan which is located at the back of the wine cellar next to the compressor from where it evaporates. HUMIDITY MAINTENANCE SYSTEM The wine cellar is equipped with a system for maintaining the correct level of humidity.
