Instruction manual

12
5/ OPERATIONAL ANOMALIES
SYMPTOM SOLUTION
The hood does not
work...
Check that:
• Thereisnotapoweroutage.
• Aspecificspeedhasactuallybeenselected.
• Thepanelishungproperly.
• The9poleconnectionisinsertedproperly.
• Theredresetkey,foundovertheelectricsystembox,ispushed.
• Makesurethatthewiresareinsertedproperlyinthe9polecon-
nection, in the connector itself. (During the connection phase, an
excessive pressure could bend the contacts.)
The hood has low
output...
Check that:
• The motor speed selected is sufficient for the quantity of fumes
steam present.
• Thekitchenisventilatedwellenoughtoallowforairintake.
• Thecharcoalfilterisnotworn(filteringversioncookerhood).
• Theairoutletchannelisfreeandcompliantwithparagraph2.
• Thenon-returnvalvesofthesuctioningunitarefreetorotate.
The hood stops in
the middle of ope-
ration.
Check that:
• Thereisnotapoweroutage.
• Theomnipolardevicehasnottripped.
The downdraft is
not perfectly in line
with the kitchen
range support sur-
face.
Adjust the position of the body edge , by shifting the “L” brackets po-
sitioned in the short sides of the lower body (Fig.24); in order to do it,
lift the downdraft, loosen the screws, change the position until perfect
linearity of the edge is reached , then tighten the screws and put the
downdraft again inside the cabinet.
Any maintenance on your equipment should be undertaken by:
- Either your dealer,
- Or another qualified mechanic who is an authorized agent for the brand appliances.
When calling, please mention the appliance details (Type Fig. 23a and equipment Fig. 23b and
production date Fig. 23c).
This information is mentioned on the rating label and the production date one placed on the
lower side of the downdraft.
6/ AFTER SALES SERVICE