Technical data

Make sure that the mains voltage corresponds to the voltage indicated for the unit
(given on the nameplate).
The Induction-unit must always be installed on a clean, plain, and horizontal
surface only (table, cupboard, etc.). The equipment stands on non-slip rubber feet
which are permanently mounted. It must be placed so that it cannot fall down or
be moved due to a slanted position. Make sure that the requirements given in
chapter 3.1 “Installation requirements” are fully met.
Power control knob
The knob’s position in relation to the marker shows the current mode of operation.
OFF position:
‘0’ points to the marker (ο).
ON position:
Any position between MIN (minimum) and MAX (maximum) that points towards
the marker (ο).
Before doing an operational check, the user needs to know how the equipment is
operated.
Your induction unit has been placed in a suitable location and connected to the
mains supply. Make sure that the equipment stands securely and cannot move.
The power control knob is in the “0” position.
Remove all objects from the heating zone. Make sure that the heating zone is
neither cracked or broken. If the heating zone is cracked or broken, stop
immediately, turn off the equipment and pull out the mains plug.
Page 8 of 18