Instruction manual
7
SAFETY INSTRUCTIONS FOR INSTALLATION
•Fit the wall units and extractor hood before fitting the Tepan to avoid damaging the surface.
•The veneer or laminate coatings of worktops (or adjacent kitchen units) must be treated with 100 °C 
heat-resistant adhesive which will not dissolve or distort. Any backmoulds must be of heat-resistant 
material.
•This appliance may only be used in mobile installations such as ships, caravans, aircraft etc. if a risk 
assessment has been carried out by a suitably qualified engineer.
•Connection should be made via a suitable isolator or a double pole fused spur connection unit which 
complies with current national and local safety regulations, and the on/off switch should be easily 
accessible after the appliance has been built in. See “Electrical connection - Built-in Tepan” for more 
details.
•The appliance must not be built in over a fridge, fridge-freezer, freezer, dishwasher, washing machine or 
tumble dryer.
•After installation, ensure that the connection cable cannot come into contact with the underside of the 
appliance. Make sure that there is no mechanical obstruction, such as adrawer, which could damage it.
•Observe carefully the safety distances given on the following pages.
•Do not use any sealant except where expressly instructed to do so. The seal underneath the appliance 
provides a sufficient seal for the worktop (see “General installation tips”). 
All dimensions in this instruction booklet are given in mm.
Safety distance above the Tepan
A minimum safety distance must be maintained between the 
Tepan plate and the cooker hood above it. See the cooker 
hood manufacturer’s operating and installation instructions for 
details. If the 
manufactrer’s instructions are not available for the cooker 
hood, a minimum safety distance of at least 760 mm must be 
maintained. For any flammable objects, e.g. utensil rails, wall 
units etc. a minimum distance of at least 760 mm must be 
maintained between them and the appliance below.
When two or more appliances are installed together below 
a cooker hood, e.g. a Tepan and a gas hob combiset, which 
have different safety distances given in the installation 
instructions, you should select the greater distance of the two










