Instruction manual

32
BURNERS
They can be removed and washed only with soapy water.
Detergents can be used but must not be abrasive or corrosive.
Do not use abrasive sponges or pads.
Do not put in dishwasher.
After each cleaning, make sure that the burner-caps, as well as the burners, have been
well wiped off and CORRECTLY POSITIONED.
It is essential to check the correct position of the burner-caps as the least displacement
from the housing may cause serious problems.
Special attention has to be paid in order not to exchange the housing of the two
small burners shown in fig. 8.7. The burner caps can be interchangeable.
It is absolutely necessary to check the perfect housing of the burner-ring as an incorrect
housing may cause serious problems.
Check also that the electrodes for ignition are always clean in order to ensure a regular
spark.
Burner-cap ring
fully drilled
Burner-cap ring
partially drilled
REPLACING THE OVEN LIGHT BULB
Switch the oven off at the mains.
When the oven is cool unscrew and replace the bulb with another one resistant to high
temperatures (300°C), voltage 230 V (50 Hz), 15 W, E14.
Note: Oven bulb replacement is not covered by your guarantee.
Fig. 8.7