User guide
radio presets
To set a radio preset, rst follow the steps in the previous section to tune a station. Then press and hold the PRESET button
to create a preset for the current station. "P" and "# #" (the preset number) will blink on the display.
Press the TUNE UP or TUNE DOWN button to select a preset number (01-10). Press the PRESET button again to conrm
the setting and the station will be saved into memory. Repeat these steps for up to 10 presets, as desired.
Repeatedly press the PRESET button until the desired preset number appears in the display and the unit tunes to the station.
notes: Setting a new station preset will replace the previously stored station on that preset number.
improving the reception
Fully extend the FM wire antenna to increase reception sensitivity.
notes: Keep digital music players or mobile phones away from the FM antenna as this may cause interference.
Do not place the FM antenna near the AC power adaptor as this may lead to reception interference.
playing the radio
Press the POWER BUTTON to switch the unit ON. There are multiple methods to select the station of your choice.
Preset tuning mode: Press the PRESET BUTTON repeatedly to select the desired preset (P01 to P10).
Scanning mode: Press and hold < or > to scan through the frequency bands; scanning starts from the
currently-tuned station and stops when a station is received.
Manual tuning mode: Repeatedly press TUNE < or > to manually move through the frequency bands.
notes: When the unit turns ON, it is always on radio mode as default if no Line in audio cable is connected.