Installation & Assembly

KIT INSTALLATION GUIDE
Take the small wall and aach a cedar post to
it - again making sure the height from the ground
matches the other 2 walls. Add the small wall.
Drill the Timberloks™ at an angle for easier use.
Installing the Door: Use
the hardware from the
Hardware Pack and in-
stall on the door rst.
Then install the door.
Keep about 1/4” be-
tween of each side of the
door and the shower kit
when securing the door.
Applying the Corner Braces:
Each Kit comes with corner braces. Use these at
corners to act as added support for the 90 degree
angle. Note: Screws are not in the hardware pack
but any screw will do the trick.
Standard Installaon
Geng Out:
Aer the door is
installed and the latch is
in place, add the string
to the latch so that you
don’t get locked out.
That’s it! Just add the
nishing touches....and water!
Cape Cod
Shower Kits
For Finishing Touches + Accessories Installaon
See Page 13
4