Installation Instructions
Step 6
Place the Sensors in the Calibration fixture and activate the “set to standard”
button just below the sensor designation. The tab will turn yellow when
highlighted. Do this for each sensor that is place into the calibration fixture.
While it is highlighted in the yellow select the “Set to Standard: tab in the main
menu.
Repeat as needed to calibrate all the sensors being used when complete
unselect each sensor by clicking the tab it will turn from yellow to grey. The
sensors are now calibrated and read for use.
Step 7 When complete turn off the application and Selecting the Run/Stop tab.
Step 8 Turn the sensors off by holding them in the closed position for 5 seconds
The light will go out and the sensors are powered down. Repeat with each
sensor.