Technical information

Users Manual: DFM19HBV
 2007 Richardson Electronics GmbH
Division A.C.T. Kern
15
Controls & Functions
The OSD Wheel Knob
The OSD Wheel Knob is a multi-functional device located behind the LED Indicator on the right side of
the front bezel. It has three movements - rotate upward, rotate downward and press inward as a
button.
• Rotate Downward : Move Up/Right, Increase
• Rotate Upward : Move Downward/Left, Decrease
• Button Press : Execute, Do, Save
Illustration 6 – OSD Wheel Knob and LED Indicator
(1) Turn On and OFF
Press the OSD wheel knob in order to turn ON the DFM19HBV if the LED indicator is off.
In order to turn OFF, press the OSD wheel knob for 2 seconds until the LED indicator turns off as
well.
(2) LED Indicator
This LED indicator turns green when the power is switched ON and the power cord is properly
attached. It turns orange when the monitor goes into a power saving mode (standby). Please
refer to the power management section of this manual for more information.
OSD - On Screen Display usage
While the monitor is turned ON (LED indicator is green and image on the screen), pressing on the
Control Dial (OSD wheel knob) activates the OSD. While the OSD menu is active, use the three way
movements of the control dial to adjust the settings.
- rotate downward: move up / right, increase
- rotate upward: move downward / left, decrease
- button press: Execute, Do, Save
Mode Power consumption (only flat screen) LED indicator
ON Approx. 60,0 W Green
STANDBY Approx 15,0 W Orange
OFF Off, no light