Technical information

Users Manual: DFM19HBV
 2007 Richardson Electronics GmbH
Division A.C.T. Kern
11
Illustration 2 – Connectors and cabling of DFM19HBV-SDI
To connect the cables
1 24V DC connector
The power input on your flat screen is marked with DC IN 24V please put the 24V connector (4-pin)
into this slot. You will feel a little click if the connection is done correctly. Connect your power supply
with the power outlet.
2 Analog input connector (VGA)
Connect the 15pin D-Sub VGA cable to this connector and to your graphic adapter.
3 Digital input connector (DVI)
Connect the DVI cable to this connector and to your graphic adapter.
4 Control input connector (GPIO DIN-9)
5 Component/RGBS input connector
Connect a component video cable to this connector and a component video output device (f.e. DVD,
High Definition (HD), RGBS video image)
6 Component/RGBS output connector
7 S-Video input connector
S-Video signal input. Connect a S-Video signal cable to this connector and a S-Video output video
device.
8 S-Video output connector
9 CVBS Video input connector
Composite signal input. Connect a composite video cable to this connector and a video output
device.
10 CVBS/Composite Video output connector
11 SD-SDI input connector
Connect SDI video connector and a SDI video output device with a 75-Ohm coaxial cable
(e.g. Camcorder)
12 SD-SDI output connector
CAUTION:
When you disconnect the cord/cables, be sure to hold the connector and not the cable itself.