User Manual

12 13
PRODUCT NO. 088-0741-8
ASSEM BLY ASSEM BLY
Step 9
Requires D, H1, H2, H3, AA, BB, W
Attach the beams (H1, H2, H3) between the adjacent slanting bars (D) one by one
from top to bottom using the bolt (AA) and at washer (BB). Tighten the bolt
using the wrench (W).
Step 12
Requires E, P1, BB, FF
Place the panel for small roof (P1) between the slanting bars for the small roof (E),
then attach using the screw (FF) and at washer (BB).
H2
AA
D
AA
BB
BB
H2
H1
H2
H2
H3
H1
H3
D
D
BB
P1
P1
P1
P1
E
FF
E
Step 10
Requires D, R, AA, BB, W
Attach the tracking tube (R) to the adjacent slanting bars (D) below the beam (H3),
using the bolt (AA) and at washer (BB). Tighten the bolt using the wrench (W).
FF
BB
AA
R
D
BB
D
D
R
R
R
D
BB
W
AA
BB
AA
W
Step 11
Requires D, I, AA, BB, W
Attach the lower tube (I) to the protruded tip of the slanting bar (D) using the
bolt (AA) and at washer (BB). Tighten the bolt using the wrench (W).
AA
AA
BB
BB
I
I
I
I
I
D
D
D
D
BB
AA
W
NOTE:
Make sure the lower tube is assembled in a position opposite to that of the beams.
NOTE:
Make sure the beams are assembled in the inverted position.