User Manual

ASSEMBLY
Step 9
Requires
8, 9, 12, E, G, H, I, K, M.
Unfold the seat and back 12 and lay it on top of the assembled frame. Line up the
holes. Insert a bolt E (from outside to inside) through the bracket of the arm,
through a plastic washer I, through the side bar on the seat and back 12,
through a metal washer G and secure with a nut H. Do not tighten completely.
Repeat procedure for the other side. Then securely tighten all bolts and nuts for
this step.
9
Step 10
Requires
11, 12.
Put up the back and pull down the pin on the U-shaped bracket on the rear support
bar 11 then slip the support tube on the back into the U-shaped bracket in place
per drawing.
E
H
FRONT
I
9
8
8
12
12
G
H
E
12
11
11
12
12
x 2
G
I
x 2
x 2 x 2
Not actual size.
K
M