Manual

67
Parameter
Function
Event
Type

The abnormal events include: no SD card, no space, SD card error,
disconnection, IP conflict.

You need to draw a circle to enable this function.
Record
System auto activates channel to record once an alarm occurs (For
disconnection type only. See Figure 3-59. ).
You need to check the box to enable this function.
Record
Delay
System can delay the record for specified time after alarm ended. The
value ranges from 10s to 300s.
Relay Out
The corresponding alarm output channel when alarm occurs. You need
to check the box to enable this function.
Relay out
Delay
The alarm output can delay for the specified time after alarm stops. The
value ranges from 10s to 300s.
Send
email
If you enable this function, system can send out email to alarm the
specified user.
3.6 Storage
3.6.1 Record schedule and snapshot schedule/Holiday
In these two interfaces, you can add or remove the schedule record/snapshot setup. See Figure 3-61.
There are three record modes: general (auto), motion detect and alarm. There are six periods in one
day. Please make sure you have enabled the corresponding record mode in the Setup->Storage-
>Conditions.
You can view the current time period setup from the color bar.
 Green color stands for the general record/snapshot.
 Yellow color stands for the motion detect record/snapshot.
 Red color stands for the alarm record/snapshot.
In the holiday schedule interface, you can set special dates as holiday. Once you enable
record/snapshot function here, system can record/snapshot according to your setup on the holiday
schedule interface.