Product Overview

GD-01030-07-18
This unit is designed for use with inlet waste connections up to 1½” diameter the inlet connection being made with a
exible no-hub coupling (not supplied). Based on the outside diameter of the inlet/outlet these ttings will need to be
either 2” x 1 ½” or 2” x 1 ¼” reducing style couplings and are available from most plumbing wholesalers or DIY outlets.
DO NOT decrease the pipe diameter across the unit – i.e. inlet vs. outlet. Please Note : The Endura® Plaster Trap is
made of polypropylene which will not accept solvent weld cement.
Based on the use of 1½” pipe the maximum ow rate that can enter and pass through this unit is 20GPM.
Unlike a grease interceptor no ow control device is necessary in this application.
Servicing & Maintenance
Your Endura® Plaster Trap will require periodic servicing
to remove accumulated material and maximize its
ongoing eectiveness. This process can be achieved
manually by bailing out excess water, collecting
accumulated debris to a suitable container by hand
for disposal/re-use, or using a suitable wet vacuum
extraction unit. Alternatively a contractor can be usually
found locally who can use an industrial vacuum method
to remove and dispose of the entire contents on a
regular basis.
Ensure that you check the outlet screen during this
process and clean the lter mesh accordingly. It will be
necessary to check the operation of the Plaster Trap on a
weekly basis for the rst 6-8 weeks following
commissioning. This will allow you to assess the on
going schedule of maintenance.
Plaster Trap
Plaster Trap
3910PA15
A 14.5”
(368mm)
B 17.5”
(444mm)
C 3.5”
(89mm)
D 12.8”
(325mm)
E 16.3”
(414mm)
3920PA15
A 23.6”
(600mm)
B 17.5”
(151mm)
C 3.5”
(89mm)
D 12.8”
(325mm)
E 16.3”
(414mm)
Tank Dimensions
Endura® is a registered trademark.
Canplas Industries Ltd.
Separation Technologies Group
500 Veterans Drive, PO Box 1800
Barrie, ON L4M 4V3 Canada
Tel: [phone]
Toll Free: 1-800-461-5300
Fax: [phone]
Technical Support
[e-mail]