Installation & Assembly

Step 1
Step 2
Place the chair back(A) on a soft surface to avoid any scratches on
the products.
Take out the 2 wooden legs and the package of hardware
accessories.
Put the chair back( A) onto a flat table or panel.
Align the holes on chair back(A) to the holes on chair seat frame.
Use your left hand to push the seat frame floorwards, depicted by
Arrow 1.
This action helps to ensure the chair seat(B) is pressed towards to
the chair back(A) with no gap between these.
Then, lock the middle hole and the corner holes.
The hardware for these are : use 4 Bolts (a)+one Bolt(c)+ 5 Flat
Washers (e) + 5 Spring Washers (d) with the Allen key(f).
At this point of assembly, DO NOT overfasten the connections.
Arrow 1
4 of 7