Warnings: You must read this before you proceed.
Label Description Qty A Chair Back 1 B Chair Seat 1 C Front Wooden Leg 2 D Seat Base Cover 1 Description Qty a Bolt Dia.M8X90mm (L) 4 b Bolt Dia.M8X60mm (L) 4 c Bolt Dia.
Before Beginning Assembly: Unpack all the parts for a clear overview . Pack A for Locking the front legs to the front corner blocks of the seat: Four Dia.M8 Bolts:60mm(L)+four flat washer Rings +four spring washer Rings Pack B for locking the back panel of the seat to the horizontal panel of the backrest: Four Dia.M8 Bolt:90mm(L)+four flat washer Rings+four spring washer Rings One Dia.
Step 1 Place the chair back(A) on a soft surface to avoid any scratches on the products. Take out the 2 wooden legs and the package of hardware accessories. Step 2 Arrow 1 Put the chair back( A) onto a flat table or panel. Align the holes on chair back(A) to the holes on chair seat frame. Use your left hand to push the seat frame floorwards, depicted by Arrow 1. This action helps to ensure the chair seat(B) is pressed towards to the chair back(A) with no gap between these.
Step 3 Next, place the chair onto the side of a table as seen in Picture 1. You will now have the chair bottom and all 4-legs facing skywards. Insert each front leg completely vertically into each seat frame corner. PRESS FIRMLY DOWN with your hand until there is no gap. WARNING!! DO NOT POSITION THE FRONT LEG AS SHOWN IN PICTURE 2 . THIS PICTURE SHOWS THE CHAIR BACK STAYS AGAINST THE GROUND and THE FRONT LEGS HORIZONTAL IN MIDAIR.
DROP TEST Step 4 If wobble Test again 30cm ‐ 50cm Place the chair on a LEVEL SURFACE to see if it wobbles. If it wobbles, lift the chair to some 30cm to 50cm height from the ground. Keep your feet and toes well away from the drop zone. Drop the chair freely and vertically with the four legs, hitting the ground, at the same time. This Drop Test will help to ensure that all the bolts and gaps to all reach full alignment status. Test again for evenness on a LEVEL SURFACE.
of 7
