User manual

57
SpecificationsSpecifications
SpecificationsSpecifications
Specifications
Video signal formats NTSC/PAL (Compatible with SECAM for input only.
PAL is used for output format.)
* TwinPact 100 does not support 16:9 screen mode.
DV 4-pin iLINK connector (FireWire)Front terminal
6-pin iLINK connector (FireWire)Rear terminal
Analog video S video (mini DIN 4-pin) x 1
RCA pin-jack (composite) x 1
Front terminal Input
S video (mini DIN 4-pin) x 1
RCA pin-jack (composite) x 1
Rear terminal Output
Analog audio 48kHz/16-bit 2 channels
32kHz/12-bit 4 channels
(Although the data format has 4 channels, only the 2 main
channels record data. The 2 sub-channels record no
sound.)
Data
RCA pin-jack x 2 (stereo 1 line)
* This can also be used as an audio input terminal during
RGB input by setting the Mode Switch Selector.
Front terminal Input
Stereo mini-jack x 1Rear terminal Input
RGB input terminal 15-pin high density D-sub connector x 1Rear terminal Input
Compatible resolutions 1600 x 1200
Power consumption Max. 5V 2A
External dimensions (excluding protrusions) 210 (W) x 31 (H) x 148 (D)
* An RCA pin-jack is designed on the assumption that it receives signals coming from an AV device whereas a
stereo mini-jack is designed to receive signals coming from a computer sound card.
Therefore, the input level for each is configured as shown below:
• RCA pin jack: 2 Vrms
• Stereo mini jack: 1 Vrms
Power AC adapter
RCA pin-jack x 2 (stereo 1 line)Output
15-pin high density D-sub connector x 1Output
Max.
24kHz to 100kHz
Horizontal synchronization frequency
50Hz to 130kHz
Vertical synchronization frequency
Operation assurance temperature 0 to 45
o
C
Operation assurance humidity 20 to 80% (No condensation)