User manual

10
NOTE
Do not connect DV cameras to
both of the front and rear DV ter-
minals at the same time (HUB
connection not allowed.).
3. RGB IN mode : Scan Converter mode (Screen Capture mode)
This mode is used for displaying a computer screen on a TV moni-
tor by converting signal coming from the computer into signal for
TV monitors. In this mode, the TwinPact 100 converts signals rep-
resenting the computer screen coming from the RGB input con-
nector ((6) on P.7) on the back of the unit into video signal for
displaying that screen on a TV monitor, and outputs it via the video
output connector ((2) and (3) on P.7). In addition, if sound is output
from the computer's sound card to the audio input connector ((5)
on P.7), the sound is output through the audio output connector ((4)
on P.7). These RGB or audio output signals can be output to TV
monitor or SVHS VCR.
In this mode, the TwinPact 100 converts both of RGB and audio
outputs into DV signal at the same time and outputs it via the 4-pin
DV connector on the front of the unit or the 6-pin DV connector on
the back.
You can capture DV output as a video into a DV device such as DV
camera or as a motion picture into a hard disk by connecting the
computer's IEEE1394 connector and using the accessory software.
Screen action shown on a computer monitor and sound output
from the computer can be captured as DV data and saved into the
computer's hard disk.