User manual

Names and functions of componentsNames and functions of components

Names and functions of components

FrontFront

Front

(5)(1)

(2) (4)

(7) (8) (9) (10)(6)

(3)

(1) [INPUT SELECT] switch

Allows you to switch the input mode to DV, analog or RGB.

Every time you press this switch, the mode changes in the

following order:

• RGB > DV > Analog > RGB > ...

(2) DIGITAL LED

Lights while the TwinPact 100 is receiving signals from the DV

terminal and converting them to analog signals.

(3) ANALOG LED

Lights while the TwinPact 100 is receiving signals from the ana-

log terminal and converting them to DV signals.

(4) RGB LED

Lights while the TwinPact 100 is receiving signals from the RGB

terminal and converting them to analog or DV signals.

This LED blinks while any of the following settings for RGB

screen is being adjusted on the remote controller. The LED stops

blinking after the [OK] key is pressed after the adjustment.

• Brightness • Contrast • Saturation

• Sharpness • Flicker Filter • Luminance Signal

• Chrominance Signal • Zoom Ratio • Zoom Position

• Screen Size • Screen Position

(5) STATUS LED

Lights when the TwinPact 100 has detected copy-prevention

signals while it is converting signals from the analog terminal to

DV signals.