Setup guide

-44-

MediaEdge

2 Setup using DIP switches

2-1 WOL(Wake On LAN)

WOL is a feature that can start the MediaEdge-STB3 via a network when it is in a

STOP state. Shut down the MediaEdge-STB3 with DIP switch 1 on the MediaEdge-

STB3 rear panel set to ON, to activate the WOL (Wake on LAN) feature.

Note:

If the DIP switch is changed while the MediaEdge-STB3 is turned off, the changed

setting will not be reflected. Start the MediaEdge-STB3 first and then shut it down to

enable the change.

2-2 Setting Video Output Format

Setting the DIP switch 8 on the MediaEdge-STB3 rear panel to ON allows you to

specify the video output format of the MediaEdge-STB3. Specify an appropriate

format for the monitor to be used.

Note:

Otherwise, hold the [MENU] button on the remote controller when the MediaEdge-STB3

is starting up to enter the setting menu.

■

How to setup

(1) Shut down the MediaEdge-STB3, if it's operating.

(2) Set the DIP switch 8 on the MEDIAEDGE-STB3 rear panel to ON.

(3) Start the MediaEdge-STB3 and wait until the POWER LED stops ﬂ ashing

and gets lit.

(4) Pressing the [DISP] button on the remote controller to switch formats to be

displayed.

If it's switched to an appropriate video format, the "MediaEdge-STB3

Network settings" screen will be displayed. The network setting will also

become available (Refer to Chapter 2 for details).