Setup guide

-35-
MediaEdge
- FEC mode
Enables/Disables the FEC (Forward Error Correction) mode.
- Telnet
Specifi es if the Telnet function is used.
- SNMP
Specifi es the settings on SNMP, which is the protocol that collectively controls the
connected devices on the network.
- Buffering time
Select the buffering time (video delay time) from 0/200/500/1000 milliseconds.
[Serial port]
- Remote serial
Sets the remote serial communication. Select [Disabled], [Connect with the linked
server], or [Connect with the fi xed host].
Disabled: Disables remote serial communication.
Connect with the linked server: Executes the remote serial connection in sync with
the stream server connected.
Connect with the fi xed host: Always connects to a fi xed host.
- Host name or IP address
Specifies the host name or IP address of the host computer for remote serial
communication.
- Host port number
Specifi es the port number of the host computer for remote serial communication.
- Standby port number
Specifi es the port number to be used to send/receive serial commands.
- Protocol
Specifi es the communication protocol. Select TCP or UDP.
- Baud rate
Specifi es the communication speed of the serial port.
- Data bits
Specifi es the data bit length.
- Parity
Specifi es the parity (technique for detecting data errors).
- Stop Bits
Specifi es the stop bit length.