Setup guide

CAUTION
The following conditions indicate the potential for bodily harm, damage to hardware or loss of data.
Do not pull AC adapter cord when disconnecting from electrical outlet
When disconnecting the AC adapter cord, pull on the plug, not the cord itself. Pulling on the cord can
damage the cord and may result in fi re or electric shock.
Do not setup other than the Described method
Do not setup in a manner other than prescribed. Do not use while wrapped in cloth or plastic. Heat can
accumulate, causing burns, fi re or damage.
If product will not be used for an extended period
If this product will not to be used for an extended period of time, disconnect the AC adapter from the
electrical outlet.
Do not place the product on an unstable place
Do not place the product on an unstable table or slanted surface. The product may fall from it, resulting in
injuries or malfunction of the product.
Turn OFF the power when cleaning the product
When making connections with the product or cleaning the product, be sure to disconnect the power plug
beforehand. Failure to do so may result in electric shock or malfunction of the product. When cleaning the
product, do not use volatile solvents such as thinner.
Route the cables properly
Route the power cable and AV cables properly. If they catch on something, it may result in injuries or
malfunction of the product.
Precautions for use of AC adapter
The supplied AC adapter and power cord are for exclusive use of this product. Do not operate the product
with other AC adapter or in other combinations.
Lower The Volume Of The Audio Equipment
Please lower your audio equipment speaker level that is connected with the MediaEdge-STB3 when you
turn the power of the MediaEdge-STB3 ON/OFF. You may hear a loud noise when you turn the power ON/
OFF.
Do not cover the MediaEdge-STB3 ventilation
Do not use the MediaEdge-STB3 covered with a cloth or in an ill-ventilated room.
Covering the vent may cause heat inside of the product resulting in fi re or product malfunction.