Setup guide

-25-
MediaEdge
2
Use the remote controller and
check [Use the following IP
address].
3
Specify the IP address with the
remote controller.
Press the
buttons to move the cursor. Enter
the appropriate value by pressing
the [0] to[9] buttons.
In this example, the following values are
entered.
IP address 192.168.0.16
Subnet mask 255.255.255.0
Default gateway 0.0.0.0
* To delete the value at the cursor position,
press the
button.
4
Use the remote controller and
check [Use the following DNS
server address].
* Keep the [Preferred DNS server] and
[Alternate DNS server] at the default value
(0. 0. 0. 0).
5
Place the cursor on the [Set] button and press the button on the
remote controller.
MediaEdge-STB3 will restart.