Setup guide

-24-

MediaEdge

2-2

Setting IP address of MediaEdge-STB3 and URL for menu page

■

Setting MediaEdge-STB3 IP Address

Plug the power cord into an outlet,

press the RESET button on the

rear panel, and then keep holding

the

button on the remote

controller.

[MediaEdge-STB3 Network settings] will

open.

Note:

If the startup screen does not appear, unplug the MediaEdge-STB3’s power plug, wait at

least 5 seconds, and then perform step 1 again.

• If nothing appears, follow these veriﬁ cation steps:

1. Check that the POWER LED on the front of the MediaEdge-STB3 is lit. If it is not lit,

check the AC adapter and AC power cord connections.

2. Refer to Chapter 3, Section 2 "Setup using DIP switches" and configure the video

output settings of the MediaEdge-STB3 to apply to the monitor.

3. Check the video cable connections on the back of the MediaEdge-STB3 and the TV

monitor. Also, check whether the TV monitor input is switched to the input jack to which

the video cable is connected.

• If the [MediaEdge-STB3 Network settings] screen does not appear, with the

startup screen displayed:

1. Make sure to firmly press and continue holding down the

button on the remote

controller. (When the MediaEdge-STB3 receives the signal from the remote controller,

the KEY LED is lit).

2. If the KEY LED does not respond, check if the remote controller ID is properly set, and

if the remote controller’s batteries are properly installed.