Setup guide

-14-

MediaEdge

1-2 MediaEdge-STB3 setting using DHCP

MediaEdge-STB3 is conﬁ gured to use DHCP at the factory setting. In the example

of the MediaEdge network connection shown at the start of this chapter, the

following menu screen will appear on the TV monitor several seconds after the

MediaEdge-STB3 is turned on.

If the menu screen does not appear, follow the steps below to conﬁ gure the setting.

1. Check that the LINK LED on the front of MediaEdge-STB3 is lit. If it is not lit,

check if the switching Hub is powered and if the Ethernet cables are properly

connected.

2. Check that the DHCP server on the server computer is running and then,

recheck its settings. MediaEdge-STB3 does not display anything until the IP

address is obtained from the DHCP server.

See the installation chapter in the MediaEdge-SVS3 manual for the setting of the

DHCP server.

If the image is distorted, or if it is not synchronized properly, check the following

points.

- Refer to Chapter 3, Section 2 "Setup using DIP switches" and conﬁ gure the video

output settings of the MediaEdge-STB3 to apply to the monitor.

- The data transmission may not have performed properly, making the data ﬂ awed.

Make sure that the network devices (including network cables) are properly

connected and running.