Setup guide

-6-

MediaEdge

2-4 Operation mode of MediaEdge-STB3

■

Operating Modes

Menu Mode

In this mode, users select and play desired content from a menu screen. The

menu is acquired from the Web server.

The menu screen reappears after content is ﬁ nished playing.

Channel Mode

Instead of using the menu screen, this mode allows for the selection of content

using numeric buttons on the remote controller, much like changing channels on

a TV. Channel numbers 1 through 99 are available. When no content (channel) is

selected, or when the selected content is ﬁ nished playing, video deﬁ ned as the

Default Content will automatically start playing. In the Channel mode, the

relations between the channel numbers and the contents (RTSP URL) must be

speciﬁ ed in advance.

* The operating mode must be set, in advance, by an administrator. It cannot be switched while users

are operating MediaEdge-STB3.

* The operating mode is set to Menu Mode at the time of factory shipment.

■

Maintenance Mode

Holding the reset switch down for several seconds starts Maintenance Mode. In

this mode, nothing is displayed on the screen. Use a terminal program on a

computer connected to MediaEdge-STB3 via a serial cable to perform

maintenance operations. Via the serial port, you can update ﬁ rmware or execute

other operations.

2-5 Setting Up MediaEdge-STB3

Following are the directions to set up MediaEdge-STB3.

Individual client setting using a Web browser.

Use a Web browser to access the MediaEdge-STB3 you want to set up, open the

Settings page, and then configure the settings you want. You can configure

different settings on each client. You can also initialize the settings, reboot

MediaEdge-STB3, and update its ﬁ rmware.

* The setting using a Web console can be performed only by Internet Explorer 6.