Installation guide

MEDIAEDGE

IV-8. Scheduled Serial Command Settings

If you want to use the scheduled serial command, you need to configure the devices in advance.

IV-8-1. MEDIAEDGE server and STB Settings

If your system consists of the STB and MEDIAEDGE server, configuration is required on both the

MEDIAEDGE server and STB. (SWT playback client does not support the scheduled serial command.)

[1] STB settings

Set the serial mode from the Web Console in STB.

 Remote serial

“Connect to the following host” is selected, and enter the computer name or IP address of the

MEDIAEDGE server associated with the STB.

 Host port number

60001 or any port number

 Listening port number

60001 or any port number

 Protocol

UDP or TCP

 Other settings

Set Baud rate, Data bits, Parity and Stop bits according to the controlled device.