Installation guide

MEDIAEDGE
80
IV-6. Playback Client Settings
IV-6-1. Samba shared settings for storage type playback clients
When using HDMA as a storage type playback client, the user name and password for accessing the
Samba shared folder must be the same as the factory settings. If the user name and password have been
changed, restore them to the factory settings. Also, Samba sharing must be set to [Use]. If the setting
has been changed to [Do not use], set it to [Use].
* In case of ME-DEC, these Samba shared settings are unnecessary.
The factory settings are as follows.
 ME-DEC
 User name mediaedge
 Pasword none
 HDMA-4100
 User name mediaedge
 Password hdp
 HDMA-4000
 User name HDMA-4000
 Password hdp
When using SWT as a storage type playback client, access the Samba shared folder that is created by the
installer using the user and password that are created by the installer. Do not delete the following users
or shared folders, or change the privileges.
The users and shared folders that are created on the computer on which SWT is installed are as follows.
 SWT4
 User name ME-SWT-DS
 Shared folder content
 SWT3 DS
 User name ME-SWT-DS
 Shared folder content
IV-6-2. Set up ME-DEC, HDMA-4100 (if deliver contents via the Internet)
If you would like to deliver contents via the Internet, samba shared settings of previous section are not
necessary. Alternatively, set the followings settings to do cooperation with DCM:
- DCM server : Enabled
- Host name : Fully Qualified Domain Name of DCM server or IP address.
- Port number : 443
- User name : MeOperator
- Password : (*3)
*3: MeOperator’s password which has been set at [II-8-2. Change the MeOperator’s password (DCM
server)]. Default password is !QAZxdr5.
If using a proxy server is required for Internet connection, set the followings as well:
-Proxy server : host name or IP address of the proxy server
-Port (Proxy server) : port number of the proxy server for HTTPS connections