Installation guide

MEDIAEDGE
52
[9] Confirm that the message [FTP server connection succeeded] appears. then click [OK].
[10] Click [Close].
II-6-2. Change the MeOperator’s password (DCM server)
[1] From the [Start] menu, open [Control Panel] and click [System and Security] and then click
[Administrative Tools]. Next, double-click [Computer Management].
=> [Computer Management] opens.
* Please run in the DCM server.
* The above illustration is in the case of Windows Server 2008 R2. For the other OSes, please open
the [Computer Management] in the same procedure.
[2] From the tree, display [Computer Management (Local)]->[System Tools]->[Local Users and Groups]-
>[Users].
[3] Right-click [MeOperator] and click [Set Password...].
[4] Click [Proceed].
[5] Enter [New password] and [Confirm password], then click [OK].
[6] From the [Start] menu, select [All Programs]->[MEDIAEDGE]->[DisplayContentManager], and click
[DCM Configuration Tool], then move to [Server Connection]
* Please run at an arbitrary operation PC with [DCM Application] has been installed.
* Please follow the procedure only once even if there is more than one operation PC.
[7] Enter [Username] and [Password], then click [Connection Verification] and confirm that the message
[Connection succeeded] appears.
#Server name : the host name of the DCM server
#IP Address : the IP address of the DCM server
#Username : MeOperator
#Password : the password of the above user
* When “IP Address” is omitted, “Server name” is used to connect to the DCM server.
* When “Username” and “Password” are blank, the default values are used.
[8] Click [OK] to close [DCM Configuration Tool].
[9] If you would like to deliver contents via the Internet, please configure the HDMA-4100 according to
the following:
[IV-6-2. Set up ME-DEC, HDMA-4100 (if deliver contents via the Internet)]