User guide

Reference 3
84
How to use serial controlHow to use serial control
1
When the HDMA-4000 is set to scheduled playback mode, send a
command, 1PO, to the serial port and switch the unit to serial control
mode.
2
Send a command, CH, SE, to the content you want to play and move to it.
* Send TI2SECH3SE to move to Title 2, Chapter 3.
3
Send a command, PL, to start playback.
4
Set the repeat mode with the MS command, if necessary.
5
To return to the scheduled playback, send a 0PO command.
- The default state of serial control mode
Current position ..................Title 1, Chapter 1.
Address mode ....................Specified by title.
Repeat mode ......................Repeat disabled.
Operating mode .................Stopped.