User guide

137
Appendix
Remote Control ID setting
Remote Control ID settingRemote Control ID setting
You can assign the remote control ID numbers (0 to 3) to your remote controller.
The DIP switches can be found under the battery lid of the remote controller.
ON
1234
OFF
Available to change by the button operations.
(Factory default: All switches are off.)
ON
1234
OFF
ID fixed to 0 (Set only SW1 to ON)
ON
1234
OFF
ID fixed to 1 (Set only SW2 to ON)
ON
1234
OFF
ID fixed to 2 (Set only SW3 to ON)
ON
1234
OFF
ID fixed to 3 (Set only SW4 to ON)
To assign the ID number, use the numeric buttons (0 to 3) and the button. The
default remote control ID is set to 0. In this example, the procedure to assign the
remote control ID to 2 is explained.
(1) With on the remote controller held down, press the
button for longer than a second.
Note
No signal, such as sound or message, appears when the ID number is
changed.