User`s guide

– 16 –
1
Specifications
1-1 ADVC-HDM1 Hardware Specifications
Video input HD-SDI BNC × 1 (HD-SDI)
BNC × 1 (ACTIVE THROUGH compatible with
SMPTE 292M)
Video output HD-SDI BNC × 2 (compatible with SMPTE 292M)
Audio input HD-SDI Embedded audio (SMPTE 299M ch1 and ch2
only, ch3 - ch8 are ignored)
Audio output HD-SDI Embedded audio (SMPTE 299M stereo 16-bit/
48 kHz)
Time code LTC input BNC × 1
During input: Select DVITC or LTC
with the front panel
switch
During output: Both DVITC and LTC are
always output (only
enabled during HDV
mode)
LTC output BNC × 1
DVITC input Separated from
HD-SDI
DVITC output Embedded on
HD-SDI
Stream input
and output
IEEE1394 4-pin (front)
Compatible with
IEC61883-4
Cannot be used at the same time
6-pin (rear)
Compatible with
IEC61883-4
Control RS-422A CONTROLLER
× 1
Select to use (can-
not be used at the
same time), only
supports output
from AV/C com-
mand to RS422A
Cannot be used at
the same time
DEVICE × 1
RS-232C 9-pin male × 1
For control
HDV encode HD1 720, 59.94p/50p (video: 18.3
Mbps, audio stereo: MPEG1 Audio
Layer 2 384 kbps)
Set automatically through the input sig-
nal format (720p, 1080i inter-conversion
not possible)
HD2 1080, 59.94i/50i (video: 25
Mbps, audio stereo: MPEG1 Audio
Layer 2 384 kbps)
HDV decode HD1 720, 59.94p/50p
Set automatically through the output sig-
nal format (720p, 1080i inter-conversion
not possible)
HD2 1080, 59.94i/50i
ADVC_HDM1_EN.book Page 16 Tuesday, December 19, 2006 9:20 AM