User`s guide

– 9 –

Use the DIP switches on the rear panel of the ADVC-HDM1 to set the operation

mode. The default setting for all the DIP switches is OFF.

* Slide down the lever to set the DIP switch to ON.

1-3 DIP Switches

No. Name Function

IEEE1394a data rate Selects the IEEE1394a data rate

OFF: S400 ON: S200

Start mode Selects the start mode

OFF: Normal operation ON: Firmware update mode

Serial port switch Selects the serial port

OFF: RS-422A ON: RS-232C

4 Reserved Not used

MP@HL

1920 encode mode

Operates with MPEG2-TS 1920 × 1080/59.94i during encod-

ing

* This setting is ignored if the input video is not 1920 × 1080/59.94i

6, 7, 8 Encode bit rate Selects the video bit rate for encoding

* The bit rate changes are enabled from the next encoding

SW6 SW7 SW8 Operation

OFF OFF OFF 18.3 Mbps (HDV 720p) or 25 Mbps

(HDV 1080i)

* Outputs a stream compatible with the

HDV standard

* Encodes with MPEG2-TS and

25 Mbps when SW5 is ON and the

input video is 1920 × 1080/59.94i

OFF OFF ON 40 Mbps

* MPEG2-TS

OFF ON OFF 30 Mbps

* MPEG2-TS

OFF ON ON 20 Mbps

* MPEG2-TS

ON OFF OFF 18 Mbps

* MPEG2-TS

ON OFF ON 16 Mbps

* MPEG2-TS

ON ON OFF 14 Mbps

* MPEG2-TS

ON ON ON 11 Mbps

* MPEG2-TS

* The settings can be changed with the

AV/C Canopus Vendor dependent

command or via the RS-232C

ADVC_HDM1_EN.book Page 9 Tuesday, December 19, 2006 9:20 AM