Specifications

4 Chapter 1 ADVC-100 Canopus Corporation
• Digital In — Indicates that the
ADVC-100 is ready to receive digital
video.
Status light
The Status light indicates separate things
depending on which mode you are using.
• Analog In — The status light blinks
when a Macrovision-protected signal
is detected.
• Digital In — The status light blinks
when the DV audio is set at 32kHz
12bit, which is used for 4-channel
DV audio. See 4-channel mixing
mode on page 10 for more
information.
Connection Ports
The ADVC-100 has connection ports for
both S-Video and composite input, as
well as a 4-pin IEEE 1394 input/output
port.
The back of the unit has ports for both
S-Video and composite output, as well as
a 6-pin IEEE 1394 input/output. There is
also an additional S-Video input and
Audio In, which uses a standard mini-jack
interface. For best results, you should use
the S-Video composite conversion table
included in the package.
Analog input connectors
A priority order is set to the Input
connectors. If all analog input connectors
are used at the same time, the connectors
are used in the following order:
ANALOG IN
STATUS
L-AUDIO-R VIDEO IN S VIDEO IN
DV I/O
SELECT
DV Converter
C
-100
DC IN 5V
R-AUDIO OUT-LS VIDEO OUTVIDEO INDV I/O VIDEO OUTAUDIO IN