Owner Manual

EN
BEFORE ASSEMBLY
1. Please CAREFULLY READ ALL, instructions & remarks, BEFORE STARTING THE ASSEMBLY
of the Automatic Vent Opener.
2. CARRY OUT the assembly steps IN THE ORDER SET OUT in the instructions.
FITTING THE UNIT
• • A manual vent opener, if already assembled, should be removed.
• • Follow the next steps for tting the unit according to the greenhouse model
you have purchased.
• • In the last step use the plastic-knurled adjuster to adjust closing gap.
IMPORTANT INFORMATION
• • Lubricate all moving parts after tting and before each spring and autumn using light oil.
Use grease or petroleum jelly for the piston rod.
• • In case of snow accumulation during winter season and if you deploy a heating system inside
your greenhouse, please remove the Automatic Vent Opener and switch to a manual opener.
AUTOMATIC VENT OPENER - INFORMATION
TOOLS & EQUIPMENT
Work Gloves Philips Head Screwdriver
IMPORTANT ASSEMBLY STEPS
Preparing the unit for tting
Step 1:
Prior to tting the Automatic Vent Opener, the power
tube has to be cooled by placing it in a refrigerator for
approximately 30 minutes.
Step 2:
Place the cool steel piston rod against a hard surface and
push it rmly back into the power-tube.
Step 3:
Lift the Automatic Vent Opener with one hand,
and slip the threaded steel piston rod into the plasticknurled
adjuster, which is xed in the swiveling block.
Step 4:
The plastic-knurled adjuster will be used later to adjust the
vent closing position.