Installation & Assembly

8'x8' 4' Ext. Wx12'
Model Base Length No. of Packages
Bella (8' x 8') 244 cm / 96.1" 1
Bella + 4' Ext. (8'x 12') 363 cm / 142.9" 2
Bella + 4' Ext. x 2 (8' x 16') 482 cm / 189.8" 3
Bella + 4' Ext. x 3 (8' x 20') 601 cm / 236.6" 4
» During Assembly
Make sure the base is square by measuring the diagonals and level by using a spirit level.
Peel the film covering the panel. Make sure you install it with the UV protected side out.
You may use Silicon lubricant spray in order to help you slide the panels into the profiles.
Do not spray the Polycarbonate panels.
Use a rubber mallet if necessary.
All panels with the stamped words THIS SIDE OUT must be facing out to create full UV
protection. Remove plastic sticker as panels are locked in place.
During assembly you will encounter the information icon, please refer to the
relevant assembly step for additional comments and assistance.
This icon indicates
that the installer should
be inside the product.
This icon indicates that
11 the installer should be
outside the product.
Step 3: Refers only for the extension kit! The extension kit contains a base connector, either part
#8447 or #7601
Step 7: Roof window can be located only on one of the two central roof panels.
If you assemble the greenhouse with an extension module, the roof windows must be placed on
panels only as specified in the manual.
* Note: The selected placing will affect the next assembly steps.
Step 8: Please make sure you place profile and screws according to the window location (Step 7)
Step 41: In case the window is not closed properly, please go to Step 40b, release the screws,
adjust the profile and tighten the screw.
Step 44: Peel the film covering the panel. Make sure you install it with the UV protected side out.
Step 53: Choose the appropriate anchoring according to the existing base. Screws and masonry
anchors are not supplied.
Important Recommendations
Firmly connect the greenhouse to a level surface immediately after completion
of the assembly.
Anchoring this product to the ground is essential to its stability and rigidity.
It is required to complete this stage in order for your warranty to be valid.
Tighten all screws once assembly is completed.
Screws 411 and nuts 412 are used throughout the assembly process.
Screws 411 are to be assembled from the outside and nuts 412 from the inside of the greenhouse.
If not specified otherwise, do not fasten screws and nuts (411 & 412) for more than 2-3 turns.
Do not tighten them until completion of the panels'assembly.
These 2 icons indicate if screw's tightening is required or not.
However, in some steps, temporary tightening of a few screws may be needed to prevent a
profile from sliding out.