Installation & Assembly

Notes During Assembly
Use a soft platform below the parts to avoid scratches and damages.
Product dimensions can be adjusted to your specific needs:
1.The wall-mounting profile (top-back) can be adjusted from 260 to 305 cm (102.4" to 120") above ground.
The adjusting is done when measuring and drilling (Step 12).
Please note the installation recommendations' height suggested in Diagram A.
It is possible to fix the Patio Cover back wall height at the lowest point of 260 cm/102.4". This method is optional if the
assembly conditions and exterior walls do not allow to follow the suggested installation as appears in the manual.
Please note that the product appearance may slightly change as a result, however snow load weight does not change.
2. Poles distance from the wall can be adjusted from 310 to 370 cm (122" to 145.6") as suggested in Diagram B1.
Poles distance from the side edges can be adjusted from 0 to 54 cm (0" to 21.3") as suggested in Diagram B2.
The adjusting is done after assembly and before anchoring (Step 33) by sliding poles and profile 7040 +7041 at the roof
profiles' channels.
3. Wall mounting and distance from the wall determine the roof angle and the total depth of the product (distance of gutter
from the wall). Higher wall mounting and shorter distance between wall and poles increase the roof angle and shorten the
total depth as suggested in Diagram C.
During Assembly
IIIIIIIII111111111111111111111111111111111111111111111111111111111111111111111
Steps/pages marked with dashed outline are referring to the extension kit assembly.(steps 4, 7,10,18,30,34)
ir These steps are referring to the installation of the extension kit on the right side of the patio cover;
installation on the left side is possible according to same steps.
IIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIII
Steps
In case that you already own Palram Patio cover it is necessary to dismantle some parts and keep them for future use.
Step 4: Insert 15 cm (6") of prosthesis (7506) to profile 7507, set the screws as shown in diagram a,
and insert into profile 7040 / 7041.
Step 9, 10: Please apply silicone sealants to the inner and outer edges of parts 7043 + 7042 as
well as to the middle of parts 8119 + 7039 in order to prevent water from seeping in.
Step 11: Apply silicone sealants on the inner part of 8116 & 8117 and connect to the profile.
Step 20: Please apply silicone sealants above beam 7288 + 7290, in order to prevent water from seeping in.
Step 26: Make sure that the angle between the back wall profile and the panel supporting profiles
is 90 degrees. Assembly of the panels should start from the middle of the patio cover to each side alternately.
Step 33: Please adjust the poles (inside out and sideways) by sliding them to their final position prior to anchoring.
Make sure that the poles distance from the Patio cover side edge does not exceed 54 cm/21.3".
Step 34: Please make sure that distance from the poles and the kit connection to original patio cover not exceeds 60 cm.
Please note: Anchoring this product to the ground is essential to its stability and rigidity. It is required to complete
this stage (Step 35) in order for your warranty to be valid.
*Tighten all screws when completing assembly.
Note:
The wall anchoring kit supplied with this product is suitable only for concrete walls.
Other wall types need an accordant wall fixation kit.
260-305cm
102.4"-120"
.
.
I
.
- 13°
+ 17°
`..
+ -
f i -41-