Instructions / Assembly

IMPORTANT
Please read these instructions carefully before you start to assemble this product.
Please carry out the steps in the order set out in these instructions.
Keep these instructions in a safe place for future reference.
Safety advice
.
For safety purposes we strongly recommend the product to be assembled by
at least two people.
. Some parts may have sharp edges. Please be careful when handling components.
Always wear gloves, eye protection, and long sleeves when assembling or performing any
maintenance on your product.
Do not attempt to assemble the product in windy or wet conditions.
Do not attempt to assemble the product if you are tired, have taken drugs,
medications or alcohol, or if you are prone to dizzy spells.
. Dispose of all plastic bags safely - keep them away from children's reach.
. Keep children away from the assembly area.
When using a stepladder or power tools, make sure that you are following the
manufacturer's safety advice.
. Do not climb or stand on the roof.
. Do not hang or lay on the profiles.
Heavy articles should not be leaned against the poles.
Keep roof and gutters clear of snow, dirt & leaves.
.
Heavy snow load on the roof can make it unsafe to stand below or nearby.
If color was scratched during assembly it can be fixed.
Cleaning instructions
In order to clean the product, use a mild detergent solution and rinse with
cold clean water.
Do not use acetone, abrasive cleaners, or other special detergents to clean the panels.
Clean the product once assembly is complete.
Before Assembly
Choose your site carefully before beginning assembly.
The ground surface must be perfectly flat and leveled and have a solid base such
as concrete, asphalt, deck etc.
Sort the parts and check against the content parts list.
Parts should be laid out close at hand. Keep all small parts (screws etc.) in a bowl
so they do not get lost.
Please consult your local authorities if any permits are required prior to constructing
the product.
A
Attention
Please make sure you install the panels with the UV protected side
out (marked with "THIS SIDE OUT") and remove the sticker as panels are in place.
During Assembly
When encountering the information icon, please refer to the relevant assembly
step for additional comments and assistance.
During assembly use a soft surface below the parts to avoid scratches
and damages.
Steps
Step 3: It is recommended to use a cardboard or other soft material under the lowered
corner in order to avoid scratches and peeling of paint.
Step 10: Optional!
Threading an electrical cable (for a fan or lamp etc.) is possible through the roof & legs
profiles. There are 2 options through the leg; one of them requires a special drill bit.
Step 15: Note that the triangle's both sides are equal as shown in Diagram b. Insert
the screw into the hole in Profile 8200 without pressing the panel.
Step 24: Optional!
Optional - if you wish to add Palram's Curtains or Netting Set, please thread the
plastic clips through the rail in each profile.
(Palram's Curtains / Netting Set are not supplied).
Step 26: Please level the profiles' legs and adapt screws and plugs to your specific
ground type.
* Please tighten all screws when completing assembly.
Note:
Anchoring this product to the ground is essential to its stability and rigidity.
It is required to complete this stage in order for your warranty to be valid.