Installation Guide

_A
r
IMPORTANT
Please read these instructions carefully before you start to assemble this product.
Please carry out the steps in the order set out in these instructions.
Keep these instructions in a safe place for future reference.
Safety advicc
For safety purposes we strongly recommend the product to be assembled by at
least two people.
Some parts may have sharp edges. Please be careful when handling components.
Always wear gloves, eye protection, and long sleeves when assembling or
performing any maintenance on your product.
Do not attempt to assemble the product in windy or wet conditions.
Do not attempt to assemble the product if you are tired, have taken drugs,
medications or alcohol, or if you are prone to dizzy spells.
Dispose of all plastic bags safely - keep them away from children's reach.
Keep children away from the assembly area.
When using a stepladder or power tools, make sure that you are following the
manufacturer's safety advice.
Do not climb or stand on the roof.
Do not hang or lay on the profiles.
Heavy articles should not be leaned against the poles.
Keep roof and gutters clear of snow, dirt & leaves.
Heavy snow load on the roof can make it unsafe to stand below or nearby.
If color was scratched during assembly it can be fixed.
Cleaning instruction:.
In order to clean the product, use a mild detergent solution and rinse with
cold clean water.
Do not use acetone, abrasive cleaners, or other special detergents to clean the
panels.
Clean the product once assembly is complete.
lierore Assembi:,
Choose your site carefully before beginning assembly.
The ground surface must be perfectly flat and leveled and have a solid base such
as concrete, asphalt, deck etc.
Sort the parts and check against the content parts list.
Parts should be laid out close at hand. Keep all small parts (screws etc.) in a bowl so
they do not get lost.
Please consult your local authorities if any permits are required prior to
constructing the product.
If you wish to add Palram's doors / walls closure to your gazebo, please carry
out the steps in the order set out in the Ledro Enclosed Gazebo instructions.
Should you do so, some parts will be surplus.
Attention
Please make sure you install the panels with the UV protected side out
(marked with "THIS SIDE OUT") and remove the sticker as panels are in place.
Durina
Assembly
When encountering the information icon, please refer to the relevant
assembly step for additional comments and assistance.
During assembly use a soft surface below the parts to avoid scratches and damages.
Stepb
Step 6c: Carefully spread silicone glue along the cross-section of the profile and at
once attach the profiles together. Recommended to wipe the extra residue silicone.
Steps 7-13: It is recommended to use a carton or other soft material under the
lowered corner in order to avoid scratches and peeling of paint.
Step 10: Optional - if you wish to add Palram's Curtains or Netting Set, please thread
the plastic clips through the rail in each profile. (Palram's Curtains / Netting Set are
not supplied).
Steps 12+14: Drawing a: Please note that threading of the screws should be done
from the outside
Steps 13+15: Please note that threading of the screws should be made from the
bottom up.
Step 16a: Please add silicone on the inner area of part # 8327 as illustrated
Step 23a: Please drill holes in the panels to be located precisely parallel to the holes
in profiles #9250 + #9251
Step 24: Please level the profiles' legs and adapt screws and plugs to your specific
ground type.
* Please tighten all screws when completing assembly.
Do not tighten screws and nuts (8192 & 466) until completion of assembly
process. These 2 icons indicate if screws'tightening is required or not.
A
Di
1
[ :
466
el
0
]
Note:
Anchoring this product to the ground is essential to its stability and rigidity.
It is required to complete this stage in order for your warranty to be valid.