User`s manual
Camera Server Setting
2
31
Setting Up the Camera Server
Selecting the Settings
1
Setting the Limits for Connection to the Camera Server
Setting the client access limitation
In the "Connection Limitation" setup window, click the "IP
Restriction" tab.
Item
Apply same
restriction
to all clients
ON
Details Default Value
Applies the same access restrictions to all HTTP-connected
viewers, TCP-connected viewers and proxies.
None
When the "Apply same restriction to all clients" checkbox is not
ticked, this setting specifies the clients to which limits apply. Limits
can be applied individually to HTTP-connected viewers, TCP-
connected viewers and proxies.
Object
OFF
Uses IP addresses to set the client access limits applied to clients.
Putting a tick in this checkbox enables limits based on IP addresses.
Restrict clients
None
Sets the IP addresses to which connection is permitted. Up to
20 addresses can be specified. A typical specification format
is "192.168.100.10".
IP Address
None
Sets the valid bits for IP addresses to which connection is permitted.
Bits for which "0" is specified as the mask are ignored during checking.
■ Example
When a mask of 255.255.255.0 is set for IP address 192.168.100.0,
connection is permitted to addresses 192.168.100.0 to
192.168.100.255.
Address Mask
2
To limit the clients, set the IP addresses and masks.
Put a tick in the "Restrict clients" checkbox.
Click the [Add] button.
Enter the IP address and mask.
Click the [OK] button.
The specified IP address and mask appear on the list.
3
■ "IP Restriction" Settings
After you have changed the settings, click the [OK] button.
To discard the changes, click the [Cancel] button.