Manualshelf

User`s manual

ManualsBrandsCanon ManualsComputer equipmentWebView LivescopeMV
141142143144145146147148149150
146
Message
Problem
Solution
<ERROR 004001 Cgi>
failed to connect to the http server.
SERVER=<IP address>:<port number>
Connection to the HTTP server failed. This is probably caused by one of the following:
1. The URL specification for CGI is incorrect.
2. There is a problem with settings on the other party's HTTP server.
1. Launch the WebView Livescope manager and select [Setup Server Configuration]
→ [Still image service] tab → [Schedule]. Then double-click the schedule settings to
open the "Schedule Setting" panel. Select the "Upload" tab and check for errors in
the URL specified as the CGI path.
2. Check for problems with the settings on the other party's HTTP server.
(Check the port number and the security settings.)
Message
Problem
Solution
<ERROR 004002 Cgi>
failed to authenticate.
SERVER=<IP address>:<port number>
USER=<user name>
Connection to the HTTP server failed. This is probably caused by one of the following:
1. The URL specification for CGI is incorrect.
2. There is a problem with settings on the other party's HTTP server.
1. Launch the WebView Livescope manager and select [Setup Server Configuration]
→ [Still image service] tab → [Schedule]. Then double-click the schedule settings to
open the "Schedule Settings" panel. Select the "Upload" tab and check for errors in
the URL specified as the CGI path.
2. Check for problems with the settings on the other party's HTTP server.
(Check the connection privileges and the security settings.)
Message
Problem
Solution
<ERROR 004003 Cgi>
failed to start the CGI command.
CGI_URL=<URL of CGI>
<Additional information>
Connection to the HTTP server failed. This is probably caused by one of the following:
1. The URL specification for CGI is incorrect.
2. There is a problem with settings on the other party's HTTP server.
1. Launch the WebView Livescope manager and select [Setup Server Configuration]
→ [Still image service] tab → [Schedule]. Then double-click the schedule settings to
open the "Schedule Settings" panel. Select the "Upload" tab and check for errors in
the URL specified as the CGI path.
2. Check for problems with the settings on the other party's HTTP server.
(Check the port number and the security settings.)
4. CGI Startup-related Error Messages