User`s manual

136
Message
Problem
Solution
Failed to start WebView Livescope <server name> Server.
(eg. Failed to start WebView Livescope Camera Control Server.)
A problem arose and the server could not be started up successfully. This is probably
caused by one of the following:
1. The hardware used by the server (such as the video capture board) is not operating normally.
2. The driver software used by the server (the drivers for the TCP/IP server, video capture
board, etc.) is not operating normally.
3. The TCP port number used by the server is being used by another program.
4. There was a problem during camera server installation.
1. An "additional" message may be recorded in the event log. Check the log. If an
"additional" message has been recorded, proceed according to the details provided in
the message.
2. If step 1 does not resolve the problem, re-install the camera server.
Message
Problem
Solution
Failed to terminate WebView Livescope <server name> Server.
(eg. Failed to terminate WebView Livescope Camera Control Server.)
A problem arose and the server could not be shut down successfully.
1. An "additional" message may be recorded in the event log. Check the log. If an
"additional" message has been recorded, proceed according to the details provided in
the message.
2. If step 1 does not resolve the problem, restart the machine.
3. If restarting the machine does not resolve the problem, re-install the camera server.
Message
Problem
Solution
WebView Livescope <server name> server already started.
(Eg. WebView Livescope Camera Control server already started.)
The server was launched twice. A problem may have occurred during camera server
installation.
Re-install the camera server.
Message
Problem
Solution
Failed to register WebView Livescope Service Control Manager as a service.
A problem may have occurred during camera server installation.
Re-install the camera server.