User's Manual
Table Of Contents
- Introduction
- Contents
- How to Read This Document
- Top Page of the Camera
- Chapter 1 Detailed Settings
- Setting Menu
- Accessing the Setting Menu
- Setting the Administrator Password, LAN, IPv6, DNS, etc. (Network)
- Setting the Date and Time (Date and Time)
- Setting the Camera Control and External Device Name (Camera)
- Setting the Image Size, Quality and Frame Rate (Video)
- Setting HTTP/FTP Upload and E-mail Notification (Upload)
- Setting the Image Server, Audio Server and HTTP Server (Server)
- Setting the Image Buffer, Motion Detection, Audio Playback and Interval Timer (Event)
- Setting User Access Privileges (Access Control)
- IPsec Settings (IPsec)
- Setting the Items Requiring Rebooting (Reboot Item)
- Viewing Event Logs and Current Settings, and Performing Maintenance (Maintenance)
- Chapter 2 VBAdmin Tools
- Chapter 3 VB-C60 Viewer
- Chapter 4 Creating Web Pages for Video Distribution
- Chapter 5 Appendix
1-45
IPsec Settings (IPsec)
1
1
Detailed Settings
(6) [Security Gateway Address (IPv4/IPv6)]
If the IPsec operation mode was set to [Tunnel Mode] in (2), set the IP address of the security
gateway.
(7) [Destination Prefix Length]
This setting is required only when the IPsec operation mode was set to [Tunnel Mode] in (2).
Enter a desired prefix length for connection destination in a range of 0 to 128.
If IPv4 is used, enter a desired length in a range of 0 to 32.
If [ESP] or [ESP and AH] was set under [Security Protocol] in (5), the following items must be
set.
(8) [SA ESP Encryption Algorithm]
Select [AES], [3DES], [DES] or [NULL] as the ESP encryption algorithm according to the
encryption algorithm supported by the device to connect to.
Normally [AES] or [3DES] is recommended.
(9) [SA ESP Authentication Algorithm]
Select [HMAC_SHA1_96], [HMAC_MD5_96] or [No Authentication] as the ESP authentication
algorithm according to the authentication algorithm supported by the device to connect to.
If [ESP] is used alone, [No Authentication] cannot be selected.